Site Links

• Operator Certification
• Training Accreditation
• Practical Training
• Written Test
• Pre Shift Checks
• Course durations
• Medicals for Operators
• NORS Scheme

Other Links

• AES Training Services
• AES School of Motoring
• RTITB
• ITSSAR

Disclaimer

The legislative information contained on this web site is my interpretation of the law based on many years in the health and safety business. A definitive interpretation can only be given by the courts. I will therefore not be held responsible for any accident/incident/prosecution arising as a consequence of anyone using any information obtained from this web site.

 

Practical test for fork lift truck operators

Pictured left is the practical test course for fork lift truck operators as laid down by the Joint Committee of Industry Training Boards.

All accrediting bodies have agreed this is the definitive test as of April 1st 2000. Extensive piloting of this test took place before it was introduced to replace the original test which dates from 1972.

I had the somewhat dubious distinction of being one of eight instructors nationwide who undertook piloting exercises for this test for the Road Transport Industry Training Board during October and November of 1999. I still have reservations about some aspects of it but overall, it does give a good indication that a person is competent on a fork lift although the word "competent" should not be used on a certificate.

The test can be set up as a mirror image of that shown. Also the chicane need not be next to the main aisleway. In some circumstances, it may not be possible to arrange for loads to be present on both sides of the aisleway due to space constraints. In these cases the loads can all be on one side but the instructor will direct the candidate to drive so that both left and right turns are made as are made in the test shown here.

Note: If you are taking this test you should NOT have to memorise the sequence to be followed and your instructor should repeat instructions to you at each step. I have known instructors to ask trainees to memorise this! If this happens to you I suggest you point out that, even on a car test, candidates are not expected to memorise! If it persists you can always contact the respective accrediting body. For reference only. I have shown the test sequence here.

Please note. This test works on a penalty point system. There are three categories of fault as follows:

• Minor faults, (e.g. adjusting position etc), penalty = 1 point
• Medium faults, (e.g. gentle touches of the course etc), penalty = 3 points
• Serious faults, (e.g.. reversing without looking), 5 points